How To Install Wood Plastic Flooring?

When installing plastic wood flooring, especially at the horizontal connection between the floor and the floor, as well as at the connection between the end of the floor and the steps, expansion joints must be reserved. Especially during winter installation, when the floor is in a cold shrinkage state, the expansion joints should be relatively large. When summer comes, the floor will expand to a certain extent. If the expansion joint is small, it will cause the floor to arch. How to install wood plastic flooring?
The process of installing wood plastic flooring is to calculate the actual installation area, so that the raw materials for wood plastic flooring can be effectively selected. After the area conversion is completed, select the raw materials and purchase them home. Then, measure and set out on the road surface where possible for installation. Note that measuring and setting out is a meticulous task, and poor measurement and setting out can damage the expected installation goals in the future. After the measurement and setting out, the position of the light steel keel ceiling should also be determined. The position deviation of the light steel keel ceiling should be ensured to be around 1mm. After the measurement and setting out are carried out and the light steel keel ceiling is fixed, it will enter the next production process.
Then the actual installation begins. The first wooden floor should be fixed with self tapping screws without changing. Then, a level gauge should be used to measure whether the placement position is even. After the first wooden floor is placed, the wooden plastic floor should be installed in one go, and there should be a building expansion joint of about 1mm in the middle of each wooden floor. Until it is installed in the final area, fix a base plate with self tapping screws without changing it. After the installation of Yunnan wood plastic flooring is completed, the surface mud and stains should be thoroughly cleaned and the environment should be clean.
After the installation of all wooden and plastic flooring on the road surface is completed, the expansion joints of the buildings that are left vacant should be filled as much as possible. Able to use professional sealing paste to seal the joints, and able to use seasoning paste to fill the joints. After the completion of joint filling, remove the stains on the surface of the wooden floor again. After elimination, check whether the joint is leveled. If the area is not leveled, fill the joint again, and then wipe off any excess slurry.